3 Steps To Changing Your Cars Oil

Preferably, you must alter your motor oil every three months or after every 3,000 miles. If you typically drive around in hot or dusty conditions, you might even wish to change oil more often than that.

The procedure is quite necessary and as simple as one-two-three. Step one is preparing, step two is draining the oil and changing the oil filter while action three is installing the new oil.

Getting Ready

When getting ready, it is critical to have the right tools and materials on hands, such as jack stands, a socket set, and an oil drain pan. Let your vehicle engine run for 10 minutes before you remove the oil because warm oil is much easier to empty than cold. Make sure you park on a level surface or, if your car has a low clearance, jack it up or drive it onto a ramp. If you’re jacking up the car, utilize two jack stands rather of one. (An extra jack costs about $20 which is a small rate to pay to spare your face from being squished by a severely balanced vehicle.) You might wish to examine your car’s manual about the weight of oil and type of oil filter you need to utilize.

Draining the Oil and Changing the Oil Filter

To drain the oil, crawl under the automobile and try to find the oil drain plug under the engine near the front of the vehicle. Position your pan below the plug then utilize a socket wrench to loosen the plug, turning counterclockwise. When loosened, you can use your hand to get rid of the plug and the hot oil starts pouring out. Ensure all the old oil is drained into the pan. When its totally drained, clean the drain plug and the plug opening. Now replace the drain plug gasket and use a wrench to re-install the plug but don’t make it too tight.

Next, try to find the oil filter. They are usually at the side of the engine. Location the oil pan underneath the filter in case any oil stays. Unscrew the oil filter (usage gloves if it is too hot) and clean the filter area clean, especially where it installs to the engine. Dab a little bit of your new oil on the rubber seal of the brand-new filter then screw it in by hand. You do not need to utilize a wrench to tighten the oil filter.

Installing New Oil

Remove the oil filler cap that’s located at the top of the engine. Position the funnel at the opening and gradually Dont Skip Oil Changebegin gathering the brand-new oil. You might wish to examine your manual for the proper oil capability, however, generally, you will require 4 or 5 quarts of oil. Once you’re done, returned the oil filler cap. Start the engine, let it run for a minute then check the dipstick. If you need to, add more oil. Now look for any leakages near the oil drain plug and the filter. If you do find leakages, just tighten up the plug or oil filter.


You’re now done, but remember to tidy up. Thoroughly clean away any excess oil and put the old oil into a plastic container then deal with it. Don’t just put it anywhere, though. Better to take it to the recycle center or other authorized areas.

Thanks to Central Tire and Auto for providing us with a quick guide on how to properly do an oil change!